Moteur de recherche de fiches techniques de composants électroniques
Selected language     French  ▼

Delete All
ON OFF
ALLDATASHEET.FR

X  

Preview PDF Download HTML

AD7866 Datasheet(Fiches technique) 5 Page - Analog Devices

Numéro de pièce AD7866
Description  Dual 1 MSPS, 12-Bit, 2-Channel SAR ADC with Serial Interface
Télécharger  20 Pages
Scroll/Zoom Zoom In 100% Zoom Out
Fabricant  AD [Analog Devices]
Site Internet  http://www.analog.com
Logo 

AD7866 Datasheet(HTML) 5 Page - Analog Devices

 
Zoom Inzoom in Zoom Outzoom out
 5 / 20 page
background image
REV. 0
AD7866
–5–
ORDERING GUIDE
Resolution
Package
Model
Temperature Range
(Bits)
Package Description
Option
AD7866ARU
–40
°C to +85°C
12
Thin Shrink SO (TSSOP)
RU-20
AD7866BRU
–40
°C to +85°C
12
Thin Shrink SO (TSSOP)
RU-20
EVAL-AD7866CB
1
Evaluation Board
(TSSOP)
EVAL-CONTROL BRD2
2
Controller Board
NOTES
1This can be used as a stand-alone evaluation board or in conjunction with the evaluation board controller for evaluation/demonstration purposes.
2This evaluation board controller is a complete unit, allowing a PC to control and communicate with all Analog Devices evaluation boards ending in the CB designators.
PIN FUNCTION DESCRIPTIONS
Pin No.
Mnemonic
Function
1
REF SELECT
Internal/External Reference Selection Pin. Logic Input. If this pin is tied to GND, the on-chip
2.5 V reference is used as the reference source for both ADC A and ADC B. In addition, pins VREF,
DCAPA, and DCAPB must be tied to decoupling capacitors. If the REF SELECT pin is tied to a
logic high, an external reference can be supplied to the AD7866 through the VREF pin, in which
case decoupling capacitors are required on DCAPA and DCAPB. However, if the VREF pin is tied to
AGND while REF SELECT is tied to a logic low, an individual external reference can be applied
to both ADC A and ADC B through pins DCAPA and DCAPB, respectively. See Reference section.
2, 9
DCAPB, DCAPA
Decoupling capacitors are connected to these pins to decouple the reference buffer for each respective
ADC. The on-chip reference can be taken from these pins and applied externally to the rest of a
system. Depending on the polarity of the REF SELECT pin and the configuration of the VREF pin,
these pins can also be used to input a separate external reference to each ADC. The range of the
external reference is dependent on the analog input range selected. See Reference section.
3, 8
AGND
Analog Ground. Ground reference point for all analog circuitry on the AD7866. All analog input
signals and any external reference signal should be referred to this AGND voltage. Both of these
pins should connect to the AGND plane of a system. The AGND and DGND voltages should
ideally be at the same potential and must not be more than 0.3 V apart even on a transient basis.
4, 5
VB2, VB1
Analog Inputs of ADC B. Single-ended analog input channels. The input range on each channel is 0 V
to VREF or a 2
× VREF range depending on the polarity of the RANGE pin upon the falling edge of CS.
6, 7
VA2, VA1
Analog Inputs of ADC A. Single-ended analog input channels. The input range on each channel is 0 V
to VREF or a 2
× VREF range depending on the polarity of the RANGE pin upon the falling edge of CS.
10
VREF
Reference Decoupling Pin and External Reference Selection Pin. This pin is connected to the inter-
nal reference and requires a decoupling capacitor. The nominal reference voltage is 2.5 V and this
appears at the pin; however, if the internal reference is to be used externally in a system, it must be
taken from either the DCAPA or DCAPB pins. This pin is also used in conjunction with the REF SELECT
pin when applying an external reference to the AD7866. See REF SELECT pin description.
PIN CONFIGURATION
TOP VIEW
(Not to Scale)
20
19
18
17
16
15
14
13
12
11
1
2
3
4
5
6
7
8
9
10
AD7866
REF SELECT
A0
DCAPB
AGND
VB2
VB1
VA2
VA1
AGND
DCAPA
VREF
CS
SCLK
VDRIVE
DOUTB
DOUTA
DGND
DVDD
AVDD
RANGE


Html Pages

1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19  20 


Datasheet Download




Lien URL



Privacy Policy
ALLDATASHEET.FR
AllDATASHEET vous a-t-il été utile ?   [ DONATE ]  

À propos de Alldatasheet   |   Publicit   |   Contactez-nous   |   Politique de confidentialit   |   Echange de liens   |   Manufacturer List
All Rights Reserved© Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn