LA8153LF

Test Circuit

28

22

23

24

25

26

27

21

20

19

18

17

16

15

1

2

3

4

5

6

7

8

14

13

12

11

10

9

LO Buffer

RF AGC

AMP

RF Mixer

SAW

Driver

IF AGC

AMP

Post AMP

1k

Ω

AGC CONTROL

0.01

μF

f=80MHz

50

Ω

1000pF

50

Ω

f=130MHz

0.01

μF

0.01

μF

FET PROBE

FET PROBE

V

V

50

Ω

f=50MHz

1000pF

1000pF

1000pF

FET PROBE

FET PROBE

50

Ω

50

Ω

V

V

10k

Ω

Open or GND: Nomal operation

VCC: Power save mode

0.01

μF

0.01

μF

3.3V

3.3V

1000pF

1000pF

Attention

Electrostatic capacity of some pins is ±100V under the condition of C = 200pF and R = 0Ω, so please handle carefully

enough.

SANYO Semiconductor Co.,Ltd. assumes no responsibility for equipment failures that result from using

products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition

ranges, or other parameters) listed in products specifications of any and all SANYO Semiconductor Co.,Ltd.

products described or contained herein.

SANYO Semiconductor Co.,Ltd. strives to supply high-quality high-reliability products, however, any and all

semiconductor products fail or malfunction with some probability. It is possible that these probabilistic failures or

malfunction could give rise to accidents or events that could endanger human lives, trouble that could give rise

to smoke or fire, or accidents that could cause damage to other property. When designing equipment, adopt

safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not

limited to protective circuits and error prevention circuits for safe design, redundant design, and structural

design.

Upon using the technical information or products described herein, neither warranty nor license shall be granted

with regard to intellectual property rights or any other rights of SANYO Semiconductor Co.,Ltd. or any third

party. SANYO Semiconductor Co.,Ltd. shall not be liable for any claim or suits with regard to a third party's

intellctual property rights which has resulted from the use of the technical information and products mentioned

above.

Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed

for volume production.

Any and all information described or contained herein are subject to change without notice due to

product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for the

SANYO Semiconductor Co.,Ltd. product that you intend to use.

In the event that any or all SANYO Semiconductor Co.,Ltd. products described or contained herein are

controlled under any of applicable local export control laws and regulations, such products may require the

export license from the authorities concerned in accordance with the above law.

No part of this publication may be reproduced or transmitted in any form or by any means, electronic or

mechanical, including photocopying and recording, or any information storage or retrieval system, or otherwise,

without the prior written consent of SANYO Semiconductor Co.,Ltd.

This catalog provides information as of June, 2009. Specifications and information herein are subject

to change without notice.

PS No.A1485-7/7