Moteur de recherche de fiches techniques de composants électroniques
  French  ▼

Delete All


Preview PDF Download HTML

LC01-6 Fiches technique(PDF) 4 Page - Semtech Corporation

No de pièce LC01-6
Description  Low Capacitance TVS for High-Speed Telecommunication Systems
Download  7 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Fabricant  SEMTECH [Semtech Corporation]
Site Internet
Logo SEMTECH - Semtech Corporation

LC01-6 Fiches technique(HTML) 4 Page - Semtech Corporation

  LC01-6_04 Datasheet HTML 1Page - Semtech Corporation LC01-6_04 Datasheet HTML 2Page - Semtech Corporation LC01-6_04 Datasheet HTML 3Page - Semtech Corporation LC01-6_04 Datasheet HTML 4Page - Semtech Corporation LC01-6_04 Datasheet HTML 5Page - Semtech Corporation LC01-6_04 Datasheet HTML 6Page - Semtech Corporation LC01-6_04 Datasheet HTML 7Page - Semtech Corporation  
Zoom Inzoom in Zoom Outzoom out
 4 / 7 page
background image
 2004 Semtech Corp.
Device Connection Options for Protection of High-
Speed Data Lines
The LC01-6 is designed to protect high-speed data
lines from transient over-voltages which result from
lightning and ESD. The device is designed to protect
one line pair in differential (Line-to-Line) mode. Pins 1-
8 are connected to line 1 and pins 9-16 are connected
to line 2 as shown. All pins should be connected for
best results.
T1/E1 Linecard Protection
A typical long-haul T1/E1 linecard protection circuit is
shown below. The LC01-6 is connected between Tip
and Ring on the transmit and receive line pairs. It
provides protection to metallic (line-to-line) lightning
surges per Bellcore 1089 and FCC Part 68. Depending
on the application, a high voltage crowbar device (not
shown) such as a gas discharge tube (GDT) or TVS
Thyristor may be used to suppress common mode (line-
to-ground) surges. To complete the protection circuit,
the SRDA05-4 (or SRDA3.3-4 for 3.3V supplies) is
employed as the secondary IC side protection element.
This device helps prevent the transceiver from latching
up by providing fine clamping of transients that are
coupled through the transformer. Positive temperature
coefficient (PTC) resistors or fuses are also required for
AC power cross protection. For further information,
reference Semtech application note AN97-10.
Figure 2 - Connection for Differential Protection
Applications Information
Figure 1 - Schematic and Pin Configuration

Html Pages

1  2  3  4  5  6  7 

Fiches technique Télécharger

Go To PDF Page

Lien URL

Politique de confidentialité
ALLDATASHEET vous a-t-il été utile ?  [ DONATE ] 

À propos de Alldatasheet   |   Publicité   |   Contactez-nous   |   Politique de confidentialité   |   Echange de liens   |   Fabricants
All Rights Reserved©

Mirror Sites
English :  |   English :  |   Chinese :  |   German :  |   Japanese :
Russian :  |   Korean :  |   Spanish :  |   French :  |   Italian :
Portuguese :  |   Polish :  |   Vietnamese :