13

36

5.1

22.9

28

+Vcc

-Vcc

M

RL

Output

-Vcc

M

+Vcc

29.5

Terminal Pin Identification

Front view

Bottom view

Left view

General tolerance

Primary through-hole

Fastening & connection of secongary

Recommended PCB hole

+/- 0.2 mm

13 x 8.5 mm

3 pins

0.7 x 0.7 mm

1.0 mm

Safety

This transducer must be used in electric/electronic equipment

with respect to applicable standards and safety requirements

in accordance with the following manufacturer's operating

instructions.

Caution, risk of electrical shock

When operating the transducer, certain parts of the module can

carry hazardous voltage (eg. primary busbar, power supply).

Ignoring this warning can lead to injury and/or cause serious

damage.

This transducer is a built-in device, whose conducting parts

must be inaccessible after installation.

A protective housing or additional shield could be used.

Main supply must be able to be disconnected.

Mechanical characteristics

± 0.2 mm

13 x 8.5 mm

3 pins

0.7 x 0.7 mm

Recommended PCB hole

1.0 mm

061110/7

www.lem.com

LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.

Page 2/2