PIN Diode Limiter

Rev. V1

LM102202-H-C-301

3

3

M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.

Visit www.macom.com for additional data sheets and product information.

For further information and support please visit:

https://www.macom.com/support

3

Handling Procedures

Please observe the following precautions to avoid

damage:

Static and Moisture Sensitivity

These

electronic

devices

are

sensitive

to

electrostatic discharge (ESD) and can be damaged

by static electricity. Proper ESD control techniques

should be used when handling these Class 0 (HBM)

devices.

The moisture sensitivity level rating for this device is

MSL 1.

Environmental Capabilities

This limiter is capable of meeting the environmental

requirements of MIL-STD-750 and MIL-STD-202.

Thermal Grounding Caution

Product engineering dictates that the LM family of

high power limiters require proper heat sinking for

high power applications >40 dBm (10 W). MACOM

recommends using the part number PNMN13881

heat sink block which was developed for LM family.

Assembly Instructions

The LM102202-H-C-301 limiters are capable of being

placed onto circuit boards with pick and place manu-

facturing equipment from tube or tape & reel dispens-

ing. The devices are attached to the circuit board using

conventional solder re-flow or wave soldering proce-

dures with RoHS type or

Sn 60 / Pb 40 type solders

per Table I & Graph I Time-Temperature recom-

mended profile.

RF Circuit Solder Footprint, case style 301 (CS301)

Recommended RF circuit is Rogers R04350B, 10 mils thick.