uC or Logic

Basic LED Driver

Wired OR

uC or Logic

Buffer Function

LV06A

uC or Logic

LV06A

VPU

uC or Logic

LV06A

VPU

9

SN54LV06A, SN74LV06A

www.ti.com

SCES336J – MAY 2000 – REVISED JANUARY 2016

Product Folder Links: SN54LV06A SN74LV06A

Submit Documentation Feedback

Copyright © 2000–2016, Texas Instruments Incorporated

9 Application and Implementation

NOTE

Information in the following applications sections is not part of the TI component

specification, and TI does not warrant its accuracy or completeness. TI’s customers are

responsible for determining suitability of components for their purposes. Customers should

validate and test their design implementation to confirm system functionality.

9.1 Application Information

The SN74LV06A is a low drive Open drain CMOS device that can be used for a multitude of buffer type

functions. The inputs are 5.5 V tolerant and the outputs open drain and 5.5 V tolerant allowing it to translate up to

5.5 V or down to any other voltage between GND and 5.5 V.

9.2 Typical Application

Figure 5. Typical Application Schematic

9.2.1 Design Requirements

This device uses CMOS technology and is open drain so it has low output drive only. Care should be taken to

avoid bus contention because it can drive currents that would exceed maximum limits. The parallel output drive

can create fast edges into light loads so routing and load conditions should be considered to prevent ringing.

9.2.2 Detailed Design Procedure

1. Recommended Input Conditions:

–

For rise time and fall time specifications, see

Δt/ΔV in the Recommended Operating Conditions table.

–

–

2. Recommended Output Conditions:

–

Load currents should not exceed 35 mA per output and 50 mA total for the part.