38

JKX Series

• Connector preparation

of cable (see pg. 16)

• Contacts wiring : crimp contacts

1 - Select the proper crimping tool (see page 48)

2 - Adjust the crimping tool based on the wire

size “AWG”. (See wire size and crimp tool

settings on the back of this locator.)

into the insulator until the clip is fully seated

and cannot be removed.

• Contacts wiring : solder contacts

Fixed solder contacts 0.5 mm and 0.7 mm

Removable solder contacts from 0.9 mm to 1.3 mm

1 - Insert wire into solder cup and solder

1 - Insert wire into solder cup and solder

2 - Insert the contact into the insulator until the clip is fully seated and cannot be removed.

• Connector assembly

1 - In case of shielded cable, comb out the shield

insert key appears through the windows of one

bush.

4 - Position all the sub-assembly in connector

assembly well aligned.

well positionned on the flats A and B. Place a

wrench to grip flats B, use the other wrench to

tighten the backnut at the flats A following the

torque values on page 39.

Wiring and assembly

instructions :

STRAIGHT PLUG