ADE7753ARS datasheet(1/60 Pages) AD

No de pièce	ADE7753ARS

Description	Single-Phase Multifunction Metering IC with di/dt Sensor Interface

Download	60 Pages

Scroll/Zoom	100%

Fabricant	AD [Analog Devices]

Site Internet	http://www.analog.com

Logo

1 / 60 page

Single-Phase Multifunction Metering IC

with di/dt Sensor Interface

ADE7753

Rev. C

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibilityis assumedbyAnalogDevicesforitsuse,norforanyinfringementsof patentsorother

rightsofthirdpartiesthatmayresultfromitsuse.Specificationssubjecttochangewithoutnotice.No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.

Tel: 781.329.4700

www.analog.com

Fax: 781.461.3113

FEATURES

High accuracy; supports IEC 60687/61036/61268 and

IEC 62053-21/62053-22/62053-23

On-chip digital integrator enables direct interface to current

sensors with di/dt output

A PGA in the current channel allows direct interface to

shunts and current transformers

Active, reactive, and apparent energy; sampled waveform;

current and voltage rms

Less than 0.1% error in active energy measurement over a

dynamic range of 1000 to 1 at 25°C

Positive-only energy accumulation mode available

On-chip user programmable threshold for line voltage surge

and SAG and PSU supervisory

Digital calibration for power, phase, and input offset

On-chip temperature sensor (±3°C typical)

SPI® compatible serial interface

Pulse output with programmable frequency

Interrupt request pin (IRQ) and status register

Reference 2.4 V with external overdrive capability

Single 5 V supply, low power (25 mW typical)

GENERAL DESCRIPTION

The ADE77531 features proprietary ADCs and DSP for high

accuracy over large variations in environmental conditions and

time. The ADE7753 incorporates two second-order 16-bit -Δ

ADCs, a digital integrator (on CH1), reference circuitry,

temperature sensor, and all the signal processing required to

perform active, reactive, and apparent energy measurements,

line-voltage period measurement, and rms calculation on the

voltage and current. The selectable on-chip digital integrator

provides direct interface to di/dt current sensors such as

Rogowski coils, eliminating the need for an external analog

integrator and resulting in excellent long-term stability and pre-

cise phase matching between the current and voltage channels.

The ADE7753 provides a serial interface to read data, and a

pulse output frequency (CF), which is proportional to the active

power. Various system calibration features, i.e., channel offset

correction, phase calibration, and power calibration, ensure

high accuracy. The part also detects short duration low or high

voltage variations.

The positive-only accumulation mode gives the option to

accumulate energy only when positive power is detected. An

internal no-load threshold ensures that the part does not exhibit

any creep when there is no load. The zero-crossing output (ZX)

produces a pulse that is synchronized to the zero-crossing point

of the line voltage. This signal is used internally in the line cycle

active and apparent energy accumulation modes, which enables

faster calibration.

The interrupt status register indicates the nature of the interrupt,

and the interrupt enable register controls which event produces

an output on the IRQ pin, an open-drain, active low logic output.

The ADE7753 is available in a 20-lead SSOP package.

FUNCTIONAL BLOCK DIAGRAM

AVDD

RESET

DVDD

DGND

TEMP

SENSOR

ADC

DFC

x2

ADE7753

LPF2

MULTIPLIER

INTEGRATOR

CLKIN CLKOUT

DIN DOUT SCLK

REFIN/OUT

CS

IRQ

AGND

APOS[15:0]

VAGAIN[11:0]

VADIV[7:0]

IRMSOS[11:0]

VRMSOS[11:0]

WGAIN[11:0]

dt

REGISTERS AND

SERIAL INTERFACE

CFNUM[11:0]

CFDEN[11:0]

2.4V

REFERENCE

4k

PHCAL[5:0]

HPF1

LPF1

02875-A-001

V1P

V1N

V2N

V2P

PGA

ZX

SAG

CF

WDIV[7:0]

%





2

|x|

Figure 1.

1U.S. Patents 5,745,323; 5,760,617; 5,862,069; 5,872,469.

Numéro de pièce similaire - ADE7753ARS

Fabricant	No de pièce	Fiches technique	Description
Analog Devices	ADE7753ARS	449Kb / 37P	Active and Apparent Energy Metering IC with di/dt sensor interface REV. PrF 10/02
Analog Devices	ADE7753ARSRL	449Kb / 37P	Active and Apparent Energy Metering IC with di/dt sensor interface REV. PrF 10/02

More results

Description similaire - ADE7753ARS

Fabricant	No de pièce	Fiches technique	Description
Analog Devices	ADE7753	725Kb / 60P	Single-Phase Multifunction Metering IC with di/dt Sensor Interface REV. C
	ADE7759	530Kb / 32P	Active Energy Metering IC with di/dt Sensor Interface REV. 0
	ADE7759	466Kb / 36P	Active Energy Metering IC with di/dt Sensor Interface REV. A
	ADE7753	449Kb / 37P	Active and Apparent Energy Metering IC with di/dt sensor interface REV. PrF 10/02
Sames	SA9903B	530Kb / 17P	Single Phase Multifunction Energy Metering IC
Analog Devices	ADE7953	804Kb / 68P	Single Phase, Multifunction Metering IC with Neutral Current Measurement REV. A
Sames	SA9904B	552Kb / 18P	Three Phase Multifunction Energy Metering IC
Analog Devices	ADE7758	1Mb / 68P	Poly Phase Multifunction Energy Metering IC with Per Phase Information REV. A
Analog Devices	ADE7758	979Kb / 72P	Poly Phase Multifunction Energy Metering IC with Per Phase Information Rev. E
Sames	SA9103C	251Kb / 16P	SINGLE PHASE BIDIRECTIONAL POWER/ENERGY METERING IC WITH SERIAL INTERFACE

More results

ADE7753ARS Fiches technique(PDF) 1 Page - Analog Devices

ADE7753ARS Fiches technique(HTML) 1 Page - Analog Devices

Numéro de pièce similaire - ADE7753ARS

Description similaire - ADE7753ARS

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Fiches technique Télécharger

Lien URL