Electrical Characteristics

(Notes 2, 8)

(Continued)

Limits in standard typeface and typical values apply for T

temperature range. Unless otherwise specified: V

Ω, V(EN) = V

Symbol

Parameter

Conditions

Min

Typ

Max

Units

I

EN

EN Pin Current (Note 9)

V(EN) = 1.5V

1.5

µA

V(EN) = 0V

0

I

BR-ON

BR-ON Pin Current

0

≤ V

BR-ON

≤ V

IN

0µA

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the component may occur. Operating Ratings are conditions under which operation

of the device is guaranteed. Operating Ratings do not imply guaranteed performance limits. For guaranteed performance limits and associated test conditions, see

the Electrical Characteristics tables.

Note 2: All voltages are with respect to the potential at the GND pin.

Note 3: Thermal shutdown circuitry protects the device from permanent damage.

Note 4: The Human body model is a 100pF capacitor discharged through a 1.5k

Ω resistor into each pin. The machine model is a 200pF capacitor discharged

directly into each pin. MIL-STD-883 3015.7

must be satisfied for the desired output current to be realized. For more information, see the section on Output Current Capability found in this datasheet.

Note 6: In applications where high power dissipation and/or poor package thermal resistance is present, the maximum ambient temperature may have to be

Note 7: Junction-to-ambient thermal resistance (

standard JESD51-7. The test board is a 4-layer FR-4 board measuring 102mm x 76mm x 1.6mm with a 2x1 array of thermal vias. The ground plane on the board

is 50mm x 50mm. Thickness of copper layers are 36µm/18µm/18µm/36µm (1.5oz/1oz/1oz/1.5oz). Ambient temperature in simulation is 22˚C, still air. Power

dissipation is 1W. The value of

issues. For more information on these topics, please refer to Application Note 1187: Leadless Leadframe Package (LLP) and the Power Dissipation and PCB Layout

Considerations sections of this datasheet.

Note 8: All room temperature limits are 100% tested or guaranteed through statistical analysis. All limits at temperature extremes are guaranteed by correlation

using standard Statistical Quality Control methods (SQC). All limits are used to calculate Average Outgoing Quality Level (AOQL). Typical numbers are not

guaranteed, but do represent the most likely norm.

Note 9: The EN pin has an internally connected 1M

Ω pull-down resistor

Block Diagram

20072203

www.national.com

4